Q: I am satisfied with this screen, but I need to increase the resistance touch. Can I add it?
A: the following points should be confirmed if the resistive touch screen is needed:
1. Is there a touch interface (YU,YD,XL,XR) in the interface definition; 2. Confirm whether there is a PIN PIN pad with resistance touch on the FPC of the screen. If not, FPC needs to be customized.
3. Then make sure that the thickness of the backlight is 0.1mm higher than the thickness of the screen, because the resistive screen is pressed, which will squeeze into the LCD;
4. Finally, confirm whether the thickness of the resistance plus the thickness of the module meets the requirements.
